ASSEMBLY & MOUNTING
4. Disconnect the power and lay the unit on its side with the gearbox positioned over the oil pan. Remove the plugs
on each side of the gear case and allow as much of the oil as possible to drain out.
5. Steps 2-4 may be repeated as needed.
6. Apply a new layer of Teflon tape to the threads of both plugs. Reinstall the plug on the bottom side of the gear case
and fill the gearbox with LUBRIPLATE 5555 (PN 12487). Then reinstall the plug on the top side of the gear case.
4.4 LOAD REVERSE
The controller tracks the amp draw for 10 cycles (sweeps) and resets the maximum amp draw (used to reverse the motor
caused by an overload condition) automatically based on the conditions.
For example: the initial setting is 4.5 (maximum) amp draw when the WeedRoller PRO is first used. The controller
records a 3.5 amp draw (highest amp draw during 10 cycles) and resets the maximum amp draw setting from 4.5 amp
draw to 3.6 amps. The controller now reverses the WeedRoller PRO tubes if the motor draws 3.6 amps or more.
4.5 AC WEEDROLLER PRO SERVICE RECORDS
DATE
MAINTENANCE
SERVICED
BY
BEFORE RE-INSTALLATION (SHAFT DRIVE)
CHECK GEARBOX GREASE (REPLACE ANNUALLY)
CHECK PLASTIC SANDWICH PACK
CHECK MOTOR AND GEARBOX FOR OIL LEAKS
CHECK CONTROLLER
RUN UNIT IN BOTH DIRECTIONS
CHECK WIRE HARNESSES
CHECK ROLLER TUBES FOR WEAR
CHECK TUBE COUPLERS
54678-00 R010114
WeedRoller PRO Owner's/Parts Manual
17