ASSEMBLY & MOUNTING
2.12 CONNECT DRIVE HEAD TO POWER
WARNING
CAUTION
Use extreme caution when working around water and
electricity. Be sure to read and understand all warning
decals and instructions.
Use a 110 volt ground fault interrupter circuit only. Keep
the 110 volt extension cord away from water. Use extension cords rated for outdoor use only. Disconnect
WeedRoller PRO from 110 volt supply and check it
before resetting the breaker if the circuit breaker trips.
Keep the 28 volt power cord out of the water.
1. Insert the power supply stake into dry land (either your beach or yard).
2. Attach the 70 foot power supply cord to the connector on the power supply.
3. Route the power supply cord along your dock frame or fasten it underneath (so it doesn't get stepped on or fall into
the water).
4. Connect the female end of the power supply cord to the male connector on the control top box. No other wiring is
needed for the control top assembly.
5. Check your 110 volt outlet with a GFI receptacle tester.
6. Connect a 110 volt outdoor extension cord (at least 14 gauge) to the power supply. Make sure to keep all 110 volt
cords away from the water.
7. Make sure the rollers are clear from obstructions so they can turn freely.
TO WEEDROLLER
EXTENSION CORD
8 AMP
BREAKER
SWITCH
TO 110 VOLT
POWER SUPPLY
STAKE
DANGER
KEEP THE 28 VOLT CORD OUT OF THE WATER!
Use 25' and 70' optional power supply extension cords
for longer docks (see parts section for part numbers).
10
WeedRoller PRO Owner's/Parts Manual
54678-00 R010114