ASSEMBLY & MOUNTING
2.10 ATTACH DRIVE HEAD TO THE DOCK
1. Place the rear tube weldment of the drive head into the
dock mounting brackets.
2. Place a spacer between the spacer holes in one of the
brackets.
3. Insert a 3/8 x 3" carriage bolt through the bolt holes and
spacer. Add washer and nut to secure bolt.
4. Repeat this step for the remaining bracket.
5. Slide the drive head up to bring the gearbox close to the
surface and lock it in place with the adjustment knobs.
2.11 ATTACH ROLLERS
1. Temporarily remove the two yellow plugs from each
roller and re-install them when the roller has filled with
the desired water level. The water level within the roller
will determine the buoyancy of the rollers. Extreme lake
bottom conditions may require some air in the rollers
to keep the rollers from getting stuck.
2. Slide seal cover disk onto gearbox shaft.
3. Align the gearbox shaft bolt holes with the bolt holes
in the roller adapter.
4. Install 1/2" bolts, washers, and nuts provided in the
hardware kit.
5. Torque to 75 ft-lbs.
6. Press down on the rollers to submerge them in water.
7. After the rollers become filled with water, push the plugs
back into their holes.
8. Loosen the adjustment knobs and let the WeedRoller
PRO slide down in the brackets to touch the lake bottom.
REAR TUBE
WELDMENT
ADJUSTMENT
KNOB
MOUNT
BRACKET
3/8" X 3"
CRG BOLT
SPACER
3/8" SERR.
FLANGE NUT
1/2" BOLT
ROLLER ADAPTER
ASSEMBLY
SEAL COVER DISC
GEARBOX SHAFT
54678-00 R010114
WeedRoller PRO Owner's/Parts Manual
9