1
Finally, it’s time to start mixing; so pull on your gloves! Then,
you will want to clear yourself an area and grab your tools
and ingredients.
For this recipe, we have gone with a 50PG 50VG mix with
3mg nicotine and a flavour combination of banana and
strawberry. We will make 10ml of e-liquid in total.
3
2
Start off by adding 3.1ml of Propylene Glycol and 5ml of
Vegetable Glycerine into your mixing cup using a syringe.
HINT: If you are struggling to get the syringe inside the
bottle, empty your PG and VG into seperate cups.
4
Now add 0.7 ml of TFA Ripe Banana and 0.8ml of Capella
Sweet Strawberry into your mixing cup. These flavours can
be purchased from the Make My Vape online store.
Let’s add our nicotine. You may not want nicotine, in which
case, just add 0.4ml more PG. If you do want nicotine
however, then measure out 0.4ml, and add it to the mix.
HINT: Either clean or use seperate syringes to make sure
you don’t contaminate your flavours.
Note that nicotine comes in various strengths and can also
be carried in VG; For this mix, I have used 72mg strength
nicotine, carried in PG.
5
Now that all your ingredients have been added, mix them
around using your syringe and transfer the contents into
your 10ml bottle.
Screw the cap onto your bottle and give it a good shake to
make sure the heavier liquids aren’t sitting at the bottom.
6
There is one final step in mixing called steeping. This allows
the liquids to settle and combine with one another to
create a full flavour profile.
Place your bottle inside a cool, dark area such as a
cupboard and let it sit; I recommend allowing your liquid
to steep overnight. Once you’re done steeping, add the
e-liquid to your device and vape on!
CHECK OUT MAKEMYVAPE.CO.UK
FOR MIXING GUIDES, SUPPLIES AND RECIPES!
VAPOUROUND MAGAZINE AUGUST 2015 63