STEP 1:
Mount the input and output jacks, DC
power, footswitch and LED in bezel
STEP 2:
Using one of the leads from the board
section, bridge lugs 4 and 9. Solder
lug 4, leaving lug 9 unsoldered. Use a
small piece of wire and connect lugs 2
and 6, soldering lug 2 but leaving lug 6
unsoldered. Solder the negative leg of
the LED (the short one) to switch lug 1.
Note: Because of my build’s tightness, I
had to reverse the switch layout. You
can use either the layout in my picture
or in the supplied diagram. Either one
will work.
STEP 3:
In this step, we ground the whole pedal.
Working as you go, solder a wire from
switch lug 6 to the negative lug of the DC
jack, then solder lug 6. Connect the DC
jack to the sleeve lug on the input jack,
then solder the DC jack. Connect the
sleeve on the input to the sleeve on the
output. Solder the input sleeve lug, but
do NOT solder the output jack sleeve.
ToneReport.com
49