STEP 2:
Use (almost all of) the leads to form the
jumper wires. In a two-IC design, there
will be a lot of jumpers. As before, bend
the leads outward, solder and clip them.
STEP 3:
Insert the IC sockets into the board, and
place something flat like a CD case or
coaster on top, then flip over to keep the
sockets in place. Solder them in.
STEP 4:
Insert the capacitors. I had low-profile
electrolytics so they were the same height
as the film capacitors, and I combined
them into two steps. If you don’t, feel
free to turn the electrolytics into their
own step. Bend, solder, clip.
22
DIY //
Build Your Own Tim Escobedo Uglyface