STEP 2:
Using the clipped lead from the board
instructions, thread it between lugs 4
and 9 on the footswitch, and solder lug
4, leaving lug 9 unsoldered. Now, we will
ground the whole thing. The following
points need to be connected together:
Lugs 2 and 6 on the switch, both sleeve
lugs of the jacks and the negative lug on
the DC jack. Whichever order you solder
them in, leave the last connection point
unsoldered. I recommend one of the jack
sleeve lugs—they have large holes.
STEP 3:
The pots have small metal tabs that
prevent them from being mounted
properly. Snap them off with pliers, then
mount the circuit board and pots in the
enclosure. Attach the knobs at this point
if you wish. Connect all the stray wires to
where they need to go, such as lugs 5 and
7 on the footswitch, 9v power wire from
Volts pot, and the board ground wire.
STEP 4:
Finally, connect the input and output jack
tip wires to lugs 9 and 8, respectively.
Solder the as-of-yet unsoldered lug 9.
ToneReport.com
ToneReport.com
29 29