HINTS&TIPS
ACCESSCONTROL • 45
PROUD SPONSORS
OF THIS PAGE
7
8
Ensuring
the lever is
the correct
orientation
for your door,
take the
spindle from
the fixing
pack and
make sure it’s
pushed all the
way into the
lever handle.
Insert both spring sets into the
cavity in the back of the handle.
10
11
9
Next, push the cable guide and
spindle through the holes in the
door. Then slide the lugs up and down
to align with the existing holes and
push the handle onto the door. You can
now remove the cable guide, this is no
longer required.
12
Mount the internal fixing plate, making
sure the cable goes through the bottom
slot. Choose the new screw and insert
either above or below the lever – this
will correspond to where your lug was
installed in the previous step. Do not
tighten fully at this stage.
13
Make sure the arrows on the tailbar
housing are pointing up. Mount the
internal handle onto the door over
the spindle and tailbar making sure
to fold the cable into the cavity on
the internal handle. Please note: the
thumbturn should not be moved until
the ins tallation is complete.
17
You will now need to
pair a card/tag. Press
the R button to start.
The light on the front of
the lock should now turn
purple. Hold the tag/card
against the external reader
under the Yale until the light
turns green. Please note:
only one card/tag can be
paired this way, subsequent
cards/tags can be paired
later using the app.
Fit the alignment tool to the internal
fixing plate, making sure it is pushed all
the way on and the handle is parallel to
the door on both sides. Next, make sure
the alignment tool is flat against the
door and tighten all the screws fully.
14
Remove
the radio
and battery
covers. Tighten
all the screws in
place ensuring
the handle stays
aligned.
Now remove the alignment tool being
careful not to remove the spindle, this is
no longer required. Take the cable and
push it into the slot in the back of the
internal handle, lining up the two red
sides of the connector.
16
15
Now, hold the R button for fifteen
seconds, waiting for the two beeps.
Press the lever handle fully down and
release, then lift the lever handle up
fully.
Make sure the lever handle operates
freely once the screws are tightened.
Insert batteries and attached the battery
cover.
18
Press the R
button to finish.
The card/tag is
now paired.
LOCKSMITHJOURNAL.CO.UK | MAY/JUN 2017
Sponsored by Insafe International
The Yale Conexis® L1 Smart Door
Lock is now fitted. For full, detailed
fitting instructions, please refer to the
“how to” video on the Yale YouTube
channel: https://www.youtube.com/
watch?v=zX3bO-2efOI
For further information on Yale’s range
of Smart Door Locks or the complete
of Smart Living range of connected
security products, please visit www.
yale.co.uk/smart-living