Maintenance and service/Replacing bulbs
& Rear combination lights
1. Using a Phillips screwdriver, remove
the upper and lower screws that secure
the rear combination light assembly.
11-43
sembly rearward and remove it from the
vehicle.
1)
2)
1)
2)
3)
4)
Stop/tail light (This light is also used as
the rear side marker light.)
Backup light
Rear turn signal light
Tail light
Guide pins
Clip
6. Put the rear combination light assembly into place while aligning the 2 guide
pins and a catch with the guide holes and
a clip on the vehicle.
3. Remove the bulb socket from the rear
combination light assembly by turning it
counterclockwise.
4. Pull the bulb out of the bulb socket and
replace it with a new one.
5. Set the bulb socket into the rear
combination light assembly and turn it
clockwise until it locks.
2. Slide the rear combination light as– CONTINUED –