Instruments and controls/Multi function display
! Hazard warning flasher setting
3-73
1. Perform the preparation steps according to “Preparation for car settings” F3-71.
3. The current setting will be displayed.
Pull the “ /SET” switch toward you to
enter the selection mode.
5. Select “Set” by operating the “ ”
switch, and confirm the setting by pulling
the “ /SET” switch toward you.
2. Operate the “ ” or “ ” switch to
select the “Hazard Warning Flasher” item.
Then pull the “ /SET” switch toward you.
4. Select “On” or “Off” by operating the
“ ” or “ ” switch. Then pull the “ /SET”
switch toward you.
6. The system will notify you that the
setting is complete.
If the setting is not available, the following
notification will be displayed. In this case,
perform the setting procedure again.
– CONTINUED –