Instruments and controls/Hazard warning flasher
left and right.
Hazard warning flasher
! Battery drainage prevention function
When the push-button ignition switch is
left in the “ACC” or “ON” position for
approximately 1 hour, the push-button
ignition switch will be automatically
switched to “OFF” to prevent the battery
from going dead. This function is activated
when the select lever is in the “P” position.
Meters and gauges
NOTE
Liquid-crystal displays are used in
some of the meters and gauges on
the combination meter. You will find
their indications hard to see if you wear
polarized glasses.
& Combination meter illumination
& When access key does not
operate properly
Refer to “Access key – if access key does
not operate properly” F9-17.
3-7
The hazard warning flasher is used to
warn other drivers when you have to park
your vehicle under emergency conditions.
The hazard warning flasher works regardless of the position of the ignition switch.
To turn on the hazard warning flasher,
push the hazard warning button on the
instrument panel. To turn off the flasher,
push the button again.
NOTE
When the ignition switch is turned to the
“ON” position, the various parts of the
combination meter are illuminated in the
following sequence.
1. Warning lights, indicator lights, meter
needles, gauge needles and liquid crystal
display illuminate.
2. Meter and gauge indications each
show MAX position.
3. Meter and gauge indications each
show MIN position.
4. Regular illumination (for driving) begins.
When the hazard warning flasher is on,
the turn signals do not work.
– CONTINUED –