2-14
Keys and doors/Keyless access with push–button start system
first. You can then touch the door lock
sensor to lock the doors.
have not been used for 2 weeks or longer
while all doors are locked
! Locking with the rear lock button
Case 2: When the access key has been
left in the operating range for 10 minutes
or longer while all doors are locked
1)
Rear lock button
Carry the access key, close all doors
including the rear gate and press the rear
lock button. The rear gate and all doors
will be locked. Also, an electronic chirp will
sound once and the hazard warning
flashers will flash once.
! Power saving function
The keyless access function will be
disabled in the following cases to protect
the access key battery and the vehicle
battery.
Case 1: When the keyless access function and the remote keyless entry system
! Recovery from power saving
mode
When one of the following is operated, the
keyless access function will be recovered.
Case 1:
. Turn the ignition switch to the “ON”
position
. Unlock the doors by operating any
procedure other than gripping the front
passenger’s door handle
. Lock the doors
. Open a door and then close it
Case 2:
. Unlock the doors by gripping the door
handle
. Unlock the doors by pressing the rear
gate opener button
. Lock the doors by touching the door
lock sensor
. Lock or unlock the doors by using the
remote keyless entry system
. Lock or unlock the doors by using the
power door locking switch
. Open either of the front doors
! Door unlock selection function
The door unlock selection function makes
it possible to unlock the driver’s door or
the rear gate without unlocking any other
doors. You can change the setting for the
driver’s door and for the rear gate independently.
Operational: Only the driver’s door or the
rear gate will be unlocked.
Non-operational: All doors and the rear
gate will be unlocked.
For the factory setting (default setting),
refer to “Function settings” F22.
NOTE
The setting can be changed by your
SUBARU dealer. Contact your SUBARU
dealer for details. Also, for models with
the multi function display, the setting
can be changed by operating the multi
function display. For details, refer to
“Keyless access setting (models with
“keyless access with push-button start
system”)” F3-77.