[email protected] • starcoshop.com
LOAD, INFLATION PRESSURE AND SPEED
General information - Warnings!
Technical specifications in this catalogue are mainly based on
manufacturers data or the ETRTO or STRO standards, and serve as
general, basic information.
For every specific tyre and/or wheel, instructions and figures on
load, inflation pressure, speed etc. stated on the product itself, or
by the manufacturer, must be complied with.
For complete wheels, the maximum load, cold inflation pressure
and speed is always determined by the part (tyre or rim/wheel)
having the lowest capacity.
E.g. the load, cold inflation pressure and speed imposed
on the rim or wheel must never exceed the rim and wheel
manufacturers recommendations, even though the tyre might be
approved for a higher load, inflation pressure or speed.
Tyres, tubes and wheels must be used for the intended area of use
only, unless otherwise specified or permitted.
If any doubt, please consult the ETRTO or STRO technical manuals,
or contact us.
Do not mount, inflate or use any tyre/wheel combination, until all
possible doubts have been eliminated.
The STARCO Group will accept no liability due to errors, omissions
or faulty information in this catalogue.
All figures are subject to change without further notice.
Manufacturer’s, ETRTO or STRO specifications are final.
TYRES OVERALL DIAMETER AND SECTION WIDTH
General information - Warnings!
The tyre diameter and tyre section width increase naturally during
normal service. It is therefore important that the intended vehicle
is checked for sufficient clearance to allow for growth - if in any
doubt, consult STARCO for details.
162
starco.com