1
12V Battery-, Charging- and Starting System Analyzer
with integrated printer
• Suitable for 12 volt batteries (lead acid, gel, wet cell, MF,
VRLA, calcium, AGM and deep cycle batteries)
• Menu-driven, intuitive operation
• With integrated thermal printer
• Automatic control of the entire test procedure through menu
navigation
• For the quick and simple determination of battery efficiency
while taking the temperature compensation into account
• Checks the battery condition, charge status, internal resistance, cold start current value
• Battery selection takes place quickly and precisely via printing
protocol
• With verification function for the starter battery, starter and
load circuit measurement
• Printing protocol supports the argumentation for workshop
customers
• The connection to the battery takes place via two plasticcoated crocodile pole clamps
• Avoidance of an overload of the battery through too long of a
measurement time
• Illuminated and very easy to read digital display
• 1.4 metre long cable allows for flexible work
• Includes thermal paper roll
• Resistant rubber cup casing
• In sturdy plastic case
SURGE PROTECTION
2
6V + 12V Hiqh-Frequency Battery charger 4A
Electronic surge protection
• Constantly suppresses emerging voltage peaks to safe levels
and therefore protects the vehicle power supply against
overvoltages
• Prevents damage to the on-board electronics when charging
the built-in battery or even during welding work
• Maximum load 200 A (8/20 µs)
• With fuse protection
• Visibility and tone signal in the event of voltages peaks
• With reverse polarity protection
• The connection to the battery takes place via two plasticcoated crocodile pole clamps
• Sturdy workshop design
• Can be switched between 6 and 12 volts
• Designed for continuous long-term use, even with built-in
battery
• For lead acid, gel, wet cell, MF, VRLA, calcium, AGM and
deep cycle batteries
• Precise load control with microprocessor prevents overcharging and automatically switches to preservation mode after a
completed charge process and prevents a “swelling” or even
“explosion” of the battery
• Allows regeneration and recovery of deeply discharged
batteries
• Fully automatic 9-stage charging cycle
• With integrated overload and reverse polarity protection
against misuse
• Pulse charge preservation
• Splash water protected according to IP44
• Includes 3 connection cables (cigarette lighter, M6 ring eyelet
contact, crocodil