Casting the form
The test showed all rough and
weak parts of the cast form
which were caused by not well
prepared master model.
Also, the huge problem
with air bubbles (which are
the inspiration for the project)
was revealed. It was noticed,
that this type of epoxy, in
general, is vulnerable to this
problem.
TEST 9. MG-EPOX-FLASH
The required amount ≈60 gr.
Cure time was ≈30-40 minutes.
The resin is originally bright dirty
yellow. It was dyed to red.
The resin gets some heat.
The sample made with Test 4 two
part form.
Overall, the experiment with two
part form could be claimed as
successful.
50
51
Experimenting with molding and casting