Casting the form
Test 5. In this example, a single
wire was placed in the cast.
Unfortunately, the sensor has
not turned on. The wire was
not close enough to the top
surface of the casting.
TEST 4 & 5. MG-EPOX-
FLASH. FINDING THE WAYS
TO CONNECT SENSOR
The required amount ≈20-30 gr.
Cure time was ≈30-40 minutes.
The resin is originally bright dirty
yellow. It was dyed to green.
All samples made with Test 1 form.
Test 4. Foil and wire
were placed into
cast.
The experiments with wire were
not effective.
Sensor switch only
with touching back
side of the cast.
Foil gave nice effect
of reflection.
42
43
Experimenting with molding and casting