10. Guide the SAC clamping device over the
threaded bolts.
11. Screw on hexagonal nuts by hand until
these are flush with the threaded bolts (parallel
mounting of the SAC clutch tool set).
Attention: The pressure spindle must be
completely screwed back.
12. Screw the pressure spindle onto the catch
until the disc spring is actuated.
Attention: Only turn until the cover of the
pressure plate touches the support of the disc
flywheel.
13. Tension disc springs.
14. Completely turn back the pressure spindle disc spring will release tension.
15. Loosen hexagonal nuts - remove clamping
device.
16. Remove threaded bolts.
17. Screw the missing cover fastening screws
into the now free threaded receptacles on
the flywheel hand-tight. At the end, tighten all
fastening screws with the torque stipulated
according to the manufacturer’s specifications.
18. Remove the clutch centring pin.
SAC clutch installation
During the controlled removal, the work steps take place in the reverse order from the installation, whereby the use of the
centring device is not required here.
471
GD_KP_$KT-K14-$KP-AUTO-KUPPLUNG_#SALL_#APR_#V1.indb 471
27.03.2015 13:07:44