Digital Beading Magazine Issue 15 - Page 48

Step 3 Step 6 Cut a 20cm length of beading wire. Make a small loop at one end and secure with a crimp tube. Thread on assorted seed beads to make a 12cm section. Make a small loop at the opposite end and secure with a crimp tube. Repeat this Step, using the bronze seed beads. Open a 4mm jump ring and connect the lobster clasp to the etched jump ring. Step 4 Using the brown knotting cord and assorted 4mm round beads; make a knotted 12cn section of beaded cord. Make a loop at each end and secure with crimp tubes. Step 5 Open one etched jump ring and thread on the loop ends of the three bead sections. Open a second etched jump ring and thread it through the loop made in Step 1. Then add the loose ends of the bead strings. Close the jump ring. Step 7 Load one head pin with assorted beads and a bead cap. Make a wrapped loop. Repeat this until you have four bead dangles, with beads in random order. Open a 4mm jump ring and add to the loop on each bead drop. Open a 6mm jump ring, add the bead dangles. Add the jump ring to the hole at the end of the leaf stamping. Close jump ring. Step 8 Run the ribbon randomly through the chain on the bracelet. Tie knots to secure the ribbon and trim the excess.