Digital Beading Magazine Issue 15 - Page 108

To make earrings: Step 1 Cut the oval chain into the following lengths: two 1.5cm lengths and two 5mm lengths Step 2 Cut a 25cm length of 22-gauge silver wire. Wrap this around the goldstone donut and wire wrap to create a 3mm coil. Trim the wire tail. Onto the remaining wire length thread on one daisy spacer, one 6mm donut, one daisy spacer. Make a loop, thread on earring hook and then wire wrap back to last daisy spacer (Photo 2). Step 3 Cut a 20cm length of 22-gauge silver wire. Thread through the opposite side of the goldstone donut added in Step 2 – take wire to the halfway point and then bring the wire ends together at the edge of the donut. Wire wrap to create a 3mm coil. Trim the wire tail. Onto the remaining wire end, thread on one daisy spacer, one 4mm bicone, one daisy spacer. Make a loop and thread on one 5mm and one 1.5cm chain. Wire wrap back to the last daisy spacer (Photo 3). 2 Step 4 Use jump rings to attach the briolette and cosmic teardrop to the ends of the chain added in Step 3 (Photo 4). www.wishwarebeads.com.au 3 4