Digital Beading Magazine Issue 15 - Page 107

8 10 11 Step 8 Cut a 20cm length of 22-gauge silver wire. Thread one end through the opposite end link of a 5cm chain section added in Step 7. Create a 3mm wire wrapped coil and then trim the wire tail. Thread on one daisy spacer, one 4mm bicone, one daisy spacer, one 6mm donut, one daisy spacer, one 4mm bicone and one daisy spacer. Make a loop, threading the end link of one 4cm chain section onto this loop and then wire wrap back to last daisy spacer (Photo 8). Step 9 Repeat Steps 5 to 8 for other side of necklace. Step 10 Attach the toggle clasp onto the necklace ends with jump rings (Photo 10). Step 11 11a Cut a 20cm length of 22-gauge silver wire. Wire wrap around the tail of the dragonfly until secure and then wire-wrap one briolette crystal to the end of the tail, as shown (Photo 11 and 11a).