Digital Beading Magazine Issue 12 - Page 90

To make Using the hole punch, punch a hole in the bottom centre of the royal crown stamping. Rivet the crown stamping, using the bottom hole to the top hole of the shell bead. Cut a 10cm length of wire and make a simple loop at one end. Thread on the following sequence of beads: white bellflower/pink lucite bead/ pearl. Make a wrapped loop. Trim excess wire. Set aside. Cut a 7.5cm length of wire and make a loop at one end. Thread on one pink luster bellflower bead. Make a wrapped loop and trim. Set aside. Take one head pin and thread on one rhinestone ball. Trim the head pin to 1cm from the ball and make a loop. Set aside. Cut a 15cm length of wire and make a wrapped loop at one end. Thread on one white luster rondelle bead. Make a wrapped loop. Open one 4mm jump ring and connect one end loop on the white luster beaded head pin and the loop of the cross pendant. Close the jump ring. Open one 4mm jump ring and thread on both bead baubles you created at the start of this project. Connect jump ring to jump ring on the cross pendant. Open another jump ring and add the rhinestone ball to the jump ring on cross pendant. Open one oval jump ring and connect to the end loop of wrapped white lustre bead to the bottom hole on the shell bead. Cut 15cm of wire and make a wrapped loop at one end. Thread on the following bead sequence: rhinestone spacer bead/white luster rondelle/daisy spacer. Make a wrapped loop. Open one 4mm jump ring and connect the loop to the top ring on royal crown charm. To make the beaded necklace chain, cut 15cm of wire for each wrapped section.