DC Gearbox WeedRoller Owner's/Part Manual | Page 21
SERVICE & MAINTENANCE
4.6 INSTALLING OR REPLACING THE SMART SWITCH
See control top assembly diagram on page 26 for identiļ¬cation of parts. Make sure WeedRoller is disconnected from
AC power source before installing/replacing switch.
INSTALL A NEW SWITCH (REFER TO PAGE 20)
1. Open the WeedRoller cover.
2. Remove two 5/16" hex nuts from the side of the smart switch.
3. Loosen 4 locknuts securing the wire clip assemblies on top of the switch mount assembly.
4. Remove two proximity sensors form the switch mount assembly.
5. Loosen four screws on the terminal strip securing the black (input), white (input), red (output), and black (output)
wire. Refer to diagram below.
6. Remove smart switch. Reinstall smart switch by repeating steps in reverse order.
4.7 ATTACH THE PROXIMITY SENSORS
1. Thread proximity sensors through wire clips ensuring they loop around the end clip. Re