Blue Catalogue STARCO Product range, 2014 (GB) | Page 166
[email protected] • uk.starcoshop.com
LOAD, INFLATION PRESSURE AND SPEED
General information - Warnings!
Technical specifications in this catalogue are mainly based on
manufacturers data or the ETRTO or STRO standards, and serve
as a general, basic information.
For every specific tyre and/or wheel, instructions and figures on
load, inflation pressure, speed etc. stated on the product itself,
or by the manufacturer, must be complied with.
For complete wheels, the maximum load, cold inflation
pressure and speed is always determined by the part (tyre or
rim/wheel) having the lowest capacity.
Tyres, tubes and wheels must be used for the intended area of
use only, unless otherwise specified or permitted.
If any doubt, please consult the ETRTO or STRO technical
manuals, or contact us.
Do not mount, inflate or use any tyre/wheel combination, until
all possible doubts have been eliminated.
The STARCO Group will accept no liability due to errors,
omissions or faulty information in this catalogue.
E.g. the load, cold inflation pressure and speed imposed
on the rim or wheel must never exceed the rim and wheel
manufacturers recommendations, even though the tyre might
be approved for a higher load, inflation pressure or speed.
All figures are subject to change without further notice.
Manufacturer’s, ETRTO or STRO specifications are final.
TYRES OVERALL DIAMETER AND SECTION WIDTH
General information - Warnings!
The tyre diameter and tyre section width increase naturally
during normal service. It is therefore important that the
intended vehicle is checked for sufficient clearance to allow for
growth - if in any doubt, consult STARCO for details.
11.8
starco.com