ECC100
three axes piezo motion controller for driving attocube’s ECS positioners
The three axes controller ECC100 is driving and controlling all ECS
positioners in open and closed loop mode. The ECC100 can be controlled
through USB, input/output triggers, or Ethernet (optional) and is
DEVELOPMENT
€
MIO. €
PRODUCTS
delivered with Windows based Software, DLL, LabViewTM, and EPICS
(optional) drivers set.
SOFT/HARDWARE
€
R&D ENGINEER
REVENUE
MIC
available in our webshop
shop.attocube.com
DEVELOPMENT
attoshop
€
MIO. €
SOFT/HARDWARE
€
REVENUE
R&D ENGINEER
Modes of Operation
Output Signals
versions ECC100/STD, /PRO, /SYNC, /SYNC/PRO stepping - voltage range 0 .. 45 V
open loop positioning stepping signals for ECS positioners stepping - frequency range closed loop positioning closed loop control for ECS/NUM positioners 0 .. 5 kHz (1 axis)
0 .. 2 kHz (3 axes simultaneously)
remote operation USB 2.0 stepping - maximum current > 5 A peak
resolution of signal generation 680 µV (16 bit)
output noise < 5 mVpp (500 kHz bandwidth)
maximum capacitance load 2 µF
15-Pin SubD connector
Controller Hardware
chassis approx. 21 x 21 x 5 cm 3 weight 1.9 kg power supply 100/115/230 V, 50 .. 60 Hz output connectors power consumption max. 100 W Trigger Signals connector IEC inlet trigger level definition TTL, optionally A-quad-B
connecting cable (ELE - POS) 1 per axis, length: 2 m input trigger 1 per axis
trigger interface GPIO - port
Software Drivers
Windows, Linux
Stand-alone application for Windows XP TM ,
Vista TM , 7 TM , 8 TM
DLL
LabVIEW TM
Options and Upgrades
/PRO software upgrade activation code (art. no. 1007995)
/SYNC ethernet upgrade activation code (art. no. 1007438)
attoNAV SpaceNavigator ® (art. no. 1009915)