attoPUBLICATIONS attoCATALOG-2017/18 | Page 106

PAGE 104 Specifications attoAFM I General Specifications type of instrument cantilever based AFM with interferometric deflection detection sensor head specifics attoAFM I+ head feat. alignment-free cantilever holder tip exchange in less than 2 minutes alignment-free cantilever holder (default) compatible with PointProbe® Plus XY-Alignment Series by Nanosensors conventional cantilever holder (optional) compatible with standard commercial cantilevers Operation Modes imaging modes contact mode, non-contact mode, constant height, constant force slope compensation 2 axis scan plane correction z feedback PI feedback loop for amplitude modulation (AM), phase modulation (PM) or frequency modulation (FM) using included PLL, constant force incl. standard techniques AFM optional upgrades KPFM, PFM, conductive-tip AFM Resolution* measured RMS z-noise (constant force @ 4 K, 5 ms pixel time) < 0.05 nm (expected for attoLIQUID) < 0.10 nm (expected for attoDRY) < 0.15 nm (guaranteed) z deflection noise density < 3 pm/√Hz (dependent on laser system) lateral magnetic resolution < 20 nm (attoLIQUID), < 50 nm (attoDRY) z bit resolution @ 4 K 57 pm at 15 μm scan range Sample Positioning total travel range 5 x 5 x 5 mm³ (open loop) step size 0.05..3 μm @ 300 K, 10..500 nm @ 4 K fine scan range 50 x 50 x 24 μm³ @ 300 K 30 x 30 x 15 μm³ @ 4 K closed loop scanning optional sample holder ASH/QE/4CX quick-exchange sample holder with 8 electrical contacts, integrated heater calibrated temperature sensor Suitable Operating Conditions temperature range 1.5 K..300 K (dependent on cryostat); mK compatible setup available on request magnetic field range 0..15 T+ (dependent on magnet) operating pressure designed for He exchange gas (vacuum compatible version down to 1E-6 mbar on request) Suitable Cooling Systems titanium housing diameter 48 mm bore size requirement designed for a 2" (50.8 mm) cryostat/magnet bore compatible cryostats attoDRY1000/1100/2100 attoLIQUID1000/2000/3000/5000 * Resolution may vary depending on applied tip, sample, and cryostat The attoAFM I microscope stick