Description
The unit is formed of a set of stamped plates (P) and gaskets tightened between 2 plates, one fixed (F) and one movable (B),
using compression bolts (T). The gaskets (J) create flow channels between the plates and prevent venting to the atmosphere.
The connection for the fluids is created by 4 tubes (M) integrated into the plate(s) or added.
M
B
T
COOLING
J
F
P
Compact footprint
Double gasket between fluids
Note: selection of single pass exchange is the only scenario in which the 4 tubes are fitted on the same plate.
Heating selection
Due to the range’s extreme modularity, the selection has
been optimised based on the thermal requirements and
the allowable pressure drops for the fluids utilised. The
importance of this factor must not be underestimated when
selecting a heat exchanger, as it influences the choice and
number of plates and thus the transfer area.
The transfer area is also influenced by other factors, such as
the height to width ratio, the gap between the plates, and the
angle and depth of the chevron patterns.
The thermal performance of 10TE heat exchangers is
guaranteed.
Advantages
■■ Excellent transfer coefficient, giving a reduced surface
area
■■ Very low pinch point temperatures possible
■■ High corrosion resistance
■■ Compact footprint
■■ Easy to install
■■
■■
■■
■■
■■
Low-capacity circuits and fluid retention volume
Option of surface area extension
Unit can be cleaned in-place using a circulation system
(CIP)
Maximum differential pressure = maximum operating
pressure
Precautions
■■ Ensure the exchanger gaskets are not damaged (one per
plate):
-- Avoid water hammering and overpressure, and limit on/
off cycles.
-- Do not use 1/4-turn valves.
-- Use with steam between 0 and 3 bar (effective).
-- Provide a control system adapted to the requirements
and which takes the low capacity of the circuits into
account.
352
■■ Ensure the plates are kept clean so they maintain their
thermal efficiency:
-- Filter fluids containing suspended particles.
-- Ensure the fluids are constantly circulating in the
exchanger to prevent any build-up or scale.
-- Install nozzles on the pipes for cleaning in place.
C
A
R
R
I
E
R
2
0
1
6
/
2
0
1
7