2015 Surfing Australia Rule Book - Page 47

JUDGING 2. EQUIPMENT SPECIFICATIONS Longboard Specifications The board length is minimum 9 feet measured from the nose to the tail on the deck of the surfboard The width dimensions are to be a total minimum 47 inches in aggregate. This is the total of the widest point, plus the width 12 inches up from the tail and 12 inches back from the nose Logger Specifications The board length is minimum 9 feet measured from the nose to the tail on the deck of the surfboard The width dimensions are to be a total minimum 51 inches in aggregate. This is the total of the widest point, plus the width 12 inches up from the tail and 12 inches back from the nose The board will have a single central fin that may be permanently fixed or attached via a fin box. There must be no provision for any other fin configuration The rails of the surfboard will be 50/50 or 60/40 from nose to tail The board will have no resin edge from rail to tail The fin will be at least 8 inches from its mounted base to the highest point A provision for attaching a leg rope should be attached / inserted into the surfboard. The use of leg ropes will determined by the conditions and at the Contest Director’s discretion The board will weigh a minimum of six (6) kilograms SUP Specifications All race boards must be of a single mould and with a fixed fin (except Prone 18’ open rudder) No straps will be allowed for SUP surfing events at the National Titles All ocean racing SUP boards will be a maximum of 14 feet in length unless otherwise specified All prone race boards will be stock and a maximum 12 feet in length unless otherwise specified NB. Team Australia competitors will have to compete on the ISA standard of 12’6 maximum. www.surfingaustralia.com 45